What is the cause of oil entrapment in gear pumps
When the gear pump is working, there is a phenomenon of trapped oil, and the reasons for this are analyzed as follows:
1. In the process of meshing transmission of gear pumps, in order to maintain stability and prevent collision and impact of gear teeth, it is necessary to ensure that the overlap coefficient of gear meshing is greater than 1 in the design, that is, before the previous pair of gear teeth are disengaged, the latter pair of gear teeth have already entered meshing, thus forming a closed tooth groove space between the two meshing points.
2. The size of the enclosed tooth slot space constantly changes during the rotation of the gear teeth, first from large to small, and then from small to large. This creates two objective conditions for the phenomenon of trapped oil.
3. When the enclosed tooth groove space shrinks, the oil remaining in the enclosed space cannot overflow, and the phenomenon of trapped oil occurs. At this point, the oil is subjected to strong compression, causing a sharp increase in pressure and squeezing out from any possible leaks, resulting in increased bearing load, power consumption, and oil temperature. When the space changes from small to large, a vacuum is generated in the trapped oil area, and the pressure is extremely low, which promotes the vaporization of oil and the precipitation of gas, resulting in cavitation, vibration, and noise.







