What are the measures to eliminate the phenomenon of trapped oil in gear pumps

1. Pressure relief groove method
This method is recommended for pump design in China and is also the most commonly used pressure relief method. On the inner side of the two end covers of the oil pump, two grooves are excavated along the common tangent direction of the two gear pitch circles, corresponding to the positions of the suction and discharge chambers, called pressure relief grooves. The two grooves are symmetrically arranged relative to the centerline of the two gears.


Before or after reaching the minimum trapped oil volume, regardless of whether the trapped oil volume increases or decreases, the gear pump guides the oil inside to the discharge chamber through the pressure relief groove on the right, or introduces the oil in the suction chamber into the trapped oil volume through the pressure relief groove on the left. This eliminates the compression and expansion of trapped oil, thus achieving the goal of eliminating the phenomenon of trapped oil.

 

2. Pressure relief hole method
Drill radial holes from each tooth tip and root of the gear, cut two crescent shaped grooves on the driven shaft, and slide the driven gear onto the driven shaft. When the trapped oil is compressed, the high-pressure oil in the trapped oil volume can be directed to the discharge chamber through the corresponding drilling holes on the driven gear tooth top or tooth root, as well as the grooves on the moving shaft; When trapped oil expands, the oil in the suction chamber can be introduced into the trapped oil volume through corresponding boreholes and grooves, thereby eliminating the phenomenon of trapped oil. The position of the center of the circular hole should be such that it can be tangent to the meshing point of the driven tooth profile, so its center should be on the meshing line.

 

3. Modified tooth profile method
This method involves machining a pressure relief surface (i.e., a thinning tooth surface) on the driven gear at an angle of a0=50c. In this way, the last meshing line among the two meshing lines that constitute the trapped oil volume is the tooth profile of the driving gear, which is replaced by a small gap between the inclined surfaces of the passive gear tooth profile, allowing the trapped oil volume to communicate with the discharge space and achieve the purpose of pressure relief.

 

4. Using helical gears or herringbone gears
The phenomenon of trapped oil only occurs in spur gear pumps. When using helical gears or herringbone gears, the meshing process of the gears is not like that of spur gears, which suddenly make linear contact and suddenly make linear disengagement, but gradually engage and gradually withdraw in a point-to-point manner, so there will be no trapped oil phenomenon.

 

You Might Also Like

Send Inquiry